Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052661 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B158F  AV Signal Stoppage (Low Battery Voltage)  


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the navigation receiver assembly dropping temporarily.

DTC No. Detection Item DTC Detection Condition Trouble Area
B158F AV Signal Stoppage (Low Battery Voltage) A video or audio signal is interrupted when the battery voltage drops. Navigation receiver assembly

WIRING DIAGRAM

E278019
0.875,1.01 2.708,1.208 1.833,0.198 10 false from Battery 3.354,1.208 3.74,1.427 0.385,0.219 10 false RAD 5.021,0.885 5.188,1.104 0.167,0.219 10 false 4 5.24,1 5.813,1.271 0.573,0.271 10 false B 5.125,1.958 5.698,2.229 0.573,0.271 10 false G105 5.135,2.125 7.052,2.365 1.917,0.24 10 false Navigation Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
E282022

Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK


b.

Check the battery voltage.

Standard Voltage:

11 to 14 V


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



Result:
Proceed to
OK
NG



OK

2.CHECK FOR DTC

NG

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE)
2.CHECK FOR DTC

b.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR


Result:
Proceed to
No DTCs are output
DTCs are output



No DTCs are output

DTCs are output

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE)
a.
E178447
1.542,0.458 1.958,0.698 0.417,0.24 2.51,1.521 2.177,1.146 true 0.156,0.104 0.458,0.302 0.302,0.198 10 false *a 1.583,0.5 1.948,0.708 0.365,0.208 10 false G105 2.542,1.542 3.021,1.792 0.479,0.25 10 false B
*a Front view of wire harness connector
(to Navigation Receiver Assembly)


Disconnect the navigation receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G105-4 (B) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR