These DTCs are stored when a malfunction occurs in the navigation receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15A0 | LAN Master Malfunction | When either condition below is met:
·
Bus malfunction ·
EEPROM error ·
DSP malfunction |
Navigation receiver assembly |
| B15AD | Navigation Processor Malfunction | When one of the conditions below is met:
·
A short to ground, short to +B or open occurs in the gyro signal circuit ·
Gyro sensor malfunction ·
GPS receiver malfunction |
Navigation receiver assembly |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit) malfunction | Navigation receiver assembly |
| B15B2 | Digital TV Tuner Malfunction | RF/IF malfunction | Navigation receiver assembly |
| B15B3 | Radio Tuner Malfunction | Tuner malfunction | Navigation receiver assembly |
| B15B5 | DVD(changer) mechanical malfunction | When one of the conditions below is met:
·
Mechanism drive signal malfunction ·
Load/Eject malfunction ·
Read mechanism malfunction ·
Mechanical malfunction |
Navigation receiver assembly |
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTCs are output again.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTCs are output