Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052661 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  USB Audio System Recognition/Play Error  


DESCRIPTION

When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the navigation receiver assembly. This diagnosis procedure is for when a device is not recognized, or files from the device cannot be played normally.

WIRING DIAGRAM

E278688
6.125,0.427 6.74,0.625 0.615,0.198 10 false USV1 5.865,0.292 6.031,0.5 0.167,0.208 10 false 1 6.125,0.854 6.74,1.052 0.615,0.198 10 false US1- 5.885,0.75 6.052,0.958 0.167,0.208 10 false 2 6.125,1.302 6.74,1.5 0.615,0.198 10 false US1+ 5.875,1.198 6.042,1.406 0.167,0.208 10 false 3 6.125,1.74 6.74,1.938 0.615,0.198 10 false UGD1 5.885,1.625 6.052,1.833 0.167,0.208 10 false 4 6.115,2.167 6.729,2.365 0.615,0.198 10 false USG1 5.885,2.042 6.052,2.25 0.167,0.208 10 false 5 0.698,0.438 1.313,0.635 0.615,0.198 10 false USV1 1.198,0.302 1.365,0.51 0.167,0.208 10 false 1 0.708,0.865 1.323,1.063 0.615,0.198 10 false US1- 1.219,0.75 1.385,0.958 0.167,0.208 10 false 2 0.688,1.302 1.302,1.5 0.615,0.198 10 false US1+ 1.208,1.188 1.375,1.396 0.167,0.208 10 false 3 0.698,1.729 1.313,1.927 0.615,0.198 10 false UGD1 1.219,1.625 1.385,1.833 0.167,0.208 10 false 4 0.708,2.177 1.323,2.375 0.615,0.198 10 false UJSS 1.219,2.063 1.385,2.271 0.167,0.208 10 false 5 3.323,2.313 3.938,2.51 0.615,0.198 10 false Shielded 5.802,2.51 6.417,2.708 0.615,0.198 10 false z10 5.802,2.688 7.031,3.052 1.229,0.365 10 false Navigation Receiver Assembly 0.219,2.5 0.833,2.698 0.615,0.198 10 false z8 0.219,2.667 1.375,3.125 1.156,0.458 10 false No. 1 Stereo Jack Adapter Assembly

CAUTION / NOTICE / HINT

HINT:
·

When a large amount of data is in a USB device, it may take a while to begin play.

·

When using a USB device, files that are protected by copyright cannot be played.

·

When files are not played in the sorted order, perform the following procedure before inspection.

1.

Add numbers in front of the file names.

2.

Put the files in a folder and copy the folder data to the USB device.




PROCEDURE

1.CHECK USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Check if playable files are present on the USB device or "iPod".

HINT:

Refer to System Description for playable files.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION



c.

Check if the USB device is a compatible format or "iPod" is a compatible version.

HINT:

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION



Result:
Result Proceed to
No playable files exist, or incompatible device format or version A
Playable files exist, and compatible device format or version B



A

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR NO PLAYABLE FILES PRESENT

B

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the z8 No. 1 stereo jack adapter assembly connector.


b.

Disconnect the z10 navigation receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
z8-1 (USV1) - z10-1 (USV1) Always Below 1 Ω
z8-2 (US1-) - z10-2 (US1-) Always Below 1 Ω
z8-3 (US1+) - z10-3 (US1+) Always Below 1 Ω
z8-4 (UGD1) - z10-4 (UGD1) Always Below 1 Ω
z8-5 (UJSS) - z10-5 (USG1) Always Below 1 Ω
z8-1 (USV1) - Body ground Always 10 kΩ or higher
z8-2 (US1-) - Body ground Always 10 kΩ or higher
z8-3 (US1+) - Body ground Always 10 kΩ or higher
z8-4 (UGD1) - Body ground Always 10 kΩ or higher
z8-5 (UJSS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK NAVIGATION RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK NAVIGATION RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)
a.
E278189
0.563,0.896 1.021,1.146 0.458,0.25 0.875,0.5 1.125,0.5 1.125,0.5 1.49,0.875 true 2.583,0.5 2.333,0.5 2.333,0.5 1.917,0.875 true 0.719,0.938 1.063,1.156 0.344,0.219 10 false z8 0.052,0.052 0.396,0.271 0.344,0.219 10 false *a 0.5,0.427 0.938,0.594 0.438,0.167 10 false USV1 2.625,0.417 3.125,0.667 0.5,0.25 10 false UGD1
*a Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Reconnect the z10 navigation receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
z8-1 (USV1) - z8-4 (UGD1) Ignition switch ACC 4.5 to 5.5 V



Result:
Proceed to
OK
NG



OK

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK

NG

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
a.

Delete all files in the USB device or "iPod" and format/restore it.


b.

Save the data again and check if it can be played on the in-vehicle device.

NOTICE:

Formatting a USB device or restoring an "iPod" erases all music on the device. Ensure that backup music data is available before performing this operation.



Result:
Proceed to
Malfunction disappears
Malfunction does not disappear



Malfunction disappears

END

Malfunction does not disappear

5.REPLACE USB DEVICE OR "iPod"
5.REPLACE USB DEVICE OR "iPod"
a.

Turn the ignition switch off.

HINT:

When this malfunction occurs, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.



b.

Turn the ignition switch to ACC.


c.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION




Result:
Proceed to
NEXT



NEXT

6.CHECK USB DEVICE OR "iPod"
6.CHECK USB DEVICE OR "iPod"
a.

Check if a USB device or "iPod" is recognized by the navigation receiver assembly, and if information such as track, artist and album names are displayed on the screen.


Result:
Proceed to
Malfunction disappears
Malfunction does not disappear



Malfunction disappears

USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE

Malfunction does not disappear

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE