Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2013.10
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052657 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when the switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

C240175
5.792,2.802 5.969,2.979 0.177,0.177 10 false 22 5.792,1.813 5.969,1.99 0.177,0.177 10 false 23 5.792,0.813 5.969,0.99 0.177,0.177 10 false 21 5.5,2.813 5.677,2.99 0.177,0.177 10 false 5 4.625,2.813 4.802,2.99 0.177,0.177 10 false 9 5.5,1.823 5.677,2 0.177,0.177 10 false 4 4.625,1.823 4.802,2 0.177,0.177 10 false 8 5.5,0.813 5.677,0.99 0.177,0.177 10 false 6 4.729,3.604 5.021,3.76 0.292,0.156 10 false G12 5.906,3.604 6.302,3.76 0.396,0.156 10 false G127 2.708,2.094 3.156,2.271 0.448,0.177 10 false MODE 6.083,2.906 6.51,3.083 0.427,0.177 10 false SW2 6.083,1.896 6.51,2.073 0.427,0.177 10 false SWG 6.083,0.906 6.51,1.083 0.427,0.177 10 false SW1 4.979,2.792 5.406,2.969 0.427,0.177 10 false AU2 4.979,1.813 5.406,1.99 0.427,0.177 10 false EAU 4.979,0.813 5.406,0.99 0.427,0.177 10 false AU1 2.75,1.083 3.188,1.302 0.438,0.219 10 false Seek+ 2.135,1.083 2.594,1.302 0.458,0.219 10 false Seek- 1.99,2.094 2.583,2.271 0.594,0.177 10 false On Hook 1.323,2.094 1.896,2.271 0.573,0.177 10 false Off Hook 1.573,1.083 2,1.365 0.427,0.281 10 false Vol+ 0.938,1.083 1.396,1.323 0.458,0.24 10 false Vol- 4.573,0.813 4.75,0.99 0.177,0.177 10 false 10 5.896,3.771 7.094,4.188 1.198,0.417 10 false Radio and Display Receiver Assembly 4.729,3.771 5.625,4.229 0.896,0.458 10 false Spiral Cable Sub-assembly 1.333,3.802 3.333,4.083 2,0.281 10 false Steering Pad Switch Assembly 1.333,3.615 1.625,3.771 0.292,0.156 10 false z3

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL


b.

Inspec the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL


b.

Inspect the spiral cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - SPIRAL CABLE)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - SPIRAL CABLE)
a.

Disconnect the G127 radio and display receiver assembly connector.


b.

Disconnect the G12 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G127-21 (SW1) - G12-6 (AU1) Always Below 1 Ω
G127-22 (SW2) - G12-5 (AU2)
G127-23 (SWG) - G12-4 (EAU)
G127-21 (SW1) - Body ground Always 10 kΩ or higher
G127-22 (SW2) - Body ground
G127-23 (SWG) - Body ground



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR