Home › ENGINE ยท 2TR-FBE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT INTELLIGENT TESTER TO DLC3*

        HINT:
        If the display indicates a communication fault in the tester, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*

        HINT:
        If necessary, record or print DTCs and freeze frame data.
        1. Check for DTCs (Click here).
        1. Check the freeze frame data (Click here).


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*

        HINT:
        Refer to the relevant section (Click here).


      NEXT


      6.CONDUCT VISUAL INSPECTION

        NEXT


        7.SET CHECK MODE DIAGNOSIS*

          HINT:
          Refer to Check Mode Procedure (Click here).


        NEXT


        8.CONFIRM PROBLEM SYMPTOMS

          HINT:
          1. Refer to Problem Symptoms Table (Click here).
          2. If the engine does not start, first perform the Check for DTC procedure and Conduct Basic Inspection procedure below.
            Result 
            Result
            Proceed to
            Malfunction does not occur
            A
            Malfunction occurs
            B



        B.
        GO TO STEP 10
        A


        9.SIMULATE SYMPTOMS

          NEXT


          10.CHECK FOR DTC*

            HINT:
            Refer to the relevant section (Click here).

            Result 
            Result
            Proceed to
            Trouble code output
            A
            No trouble code output
            B


          B.
          GO TO STEP 12
          A


          11.REFER TO DTC CHART

            HINT:
            Refer to the relevant section (Click here).


          NEXT

          GO TO STEP 14


          12.CONDUCT BASIC INSPECTION
            Result 
            Result
            Proceed to
            Malfunctioning parts not confirmed
            A
            Malfunctioning parts confirmed
            B


          B.
          GO TO STEP 17
          A


          13.REFER TO PROBLEM SYMPTOMS TABLE

            HINT:
            Refer to Problem Symptoms Table (Click here).

            Result 
            Result
            Proceed to
            Malfunctioning circuit confirmed
            A
            Malfunctioning parts confirmed
            B


          B.
          GO TO STEP 17
          A


          14.CHECK ECM POWER SOURCE CIRCUIT

            HINT:
            Refer to the relevant section (Click here).


          NEXT


          15.CONDUCT CIRCUIT INSPECTION
            Result 
            Result
            Proceed to
            Malfunction not confirmed
            A
            Malfunction confirmed
            B


          B.
          GO TO STEP 18
          A


          16.CHECK FOR INTERMITTENT PROBLEMS

            NEXT

            GO TO STEP 18


            17.CONDUCT PARTS INSPECTION

              NEXT


              18.IDENTIFY PROBLEM

                NEXT


                19.ADJUST AND/OR REPAIR

                  NEXT


                  20.CONDUCT CONFIRMATION TEST

                    NEXT

                    END