DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Both conditions are met for 2.0 seconds (1 trip detection logic): (a) The throttle actuator duty ratio is 80% or more. (b) The throttle actuator current is 0.5 A or less. |
|
| P2103 | Either condition is met (1 trip detection logic):
|
|

| 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle body with motor assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE BODY WITH MOTOR ASSEMBLY - ECM) |
Disconnect the throttle body with motor assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T1-2 (M+) - E23-14 (M+) | Always | Below 1 Ω |
| T1-1 (M-) - E23-15 (M-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| T1-2 (M+) or E23-14 (M+) - Body ground | Always | 10 kΩ or higher |
| T1-1 (M-) or E23-15 (M-) - Body ground | Always | 10 kΩ or higher |
Reconnect the throttle body with motor assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign objects between the throttle valve and housing.
|
| ||||
| OK | |
| 4.CHECK THROTTLE BODY WITH MOTOR ASSEMBLY (THROTTLE VALVE) |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||