Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR (w/ VSC)

YAW RATE AND DECELERATION SENSOR (w/ VSC) > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE SENSOR ASSEMBLY
  1. Connect the connector.

    NOTICE:
    Securely connect the connector.

  1. Install the yaw rate sensor to the crossmember.

    NOTICE:
    1. Do not use any parts which have been dropped or struck.
    2. Make sure that there is no foreign matter or carpet between the bracket of the sensor and crossmember.
    3. Do not do anything to deform the bracket of the sensor, such as kicking or stepping on it.



2. INSTALL SENSOR BRACKET
  1. Install the sensor bracket with the 2 bolts.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }



3. INSTALL FLOOR CARPET COVER
  1. Insert the floor carpet cover into the sensor bracket.

  1. Insert the positioning boss of the floor carpet cover into the hole in the bracket of the sensor.

  1. Attach the 4 claws to install the floor carpet cover.



4. INSTALL FRONT SEAT ASSEMBLY
  1. for Manual Seat:
    (Click here)

  1. for Power Seat:
    (Click here)



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(Click here)