Home › ENGINE · 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (for i-ART)

ECD SYSTEM (for i-ART) > Starter Signal Circuit

for Preparation Click here


DESCRIPTION

While the engine is being cranked, current flows from terminal ST2 of the ignition switch to the park/neutral position switch and also flows to terminal STA of the ECM (STA Signal).

WIRING DIAGRAM

Refer to DTC P0617 .

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses of circuits related to this system before performing the following inspection procedure.
  2. After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
This chart is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to Problem Symptoms Table (Click here).

1.READ VALUE USING GTS (STARTER SIGNAL)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine / Data List / Starter Signal.

  1. Read the value.

    OK:

    Ignition Switch Condition
    Starter Signal
    ON
    OFF
    START
    ON



OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG


2.CHECK HARNESS AND CONNECTOR (STARTER RELAY [ST] - ECM)
  1. Remove the starter relay (ST) from the engine room relay block and junction block assembly.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    ST relay terminal 1 - E32-6 (STA)
    Always
    Below 1 Ω
    ST relay terminal 1 or E32-6 (STA) - Body ground
    Always
    10 kΩ or higher

  1. Reinstall the starter relay (ST).

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (STARTER RELAY [ST] - ECM)
OK

REPLACE ECM (Click here)