LIGHTING SYSTEM > Headlight Signal Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (HEADLIGHT) |
Using the intelligent tester, read the Data List (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Headlight Low Beam State | Low beam headlight state / ON or OFF | ON: Low beam headlights on OFF: Low beam headlights off | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY AND BODY GROUND) |
Disconnect the C29 headlight dimmer switch connector.
Disconnect the H27 headlight leveling ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C29-20 (H) - H27-3 (B2) | Always | Below 1 Ω |
| C29-12 (EL) - Body ground | Always | Below 1 Ω |
| H27-3 (B2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY |
![]() |
Remove the headlight dimmer switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 20 (H) - 12 (EL) | Headlight dimmer switch head | Below 1 Ω |
| Headlight dimmer switch off | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||