ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR |
Install a new gasket to the sensor.
Install the sensor.
Connect the sensor connector.
| 2. INSTALL INTAKE MANIFOLD |
![]() |
Install a new gasket and the intake manifold with the 5 bolts and 2 nuts in the order shown in the illustration.
Connect the purge line hose and purge VSV connector.
Connect the fuel hose and vacuum hose.
| 3. INSTALL STARTER ASSEMBLY |
Install the starter with the 2 bolts.
Install the starter wire to terminal 30 with the nut.
Connect the terminal cap.
Connect the starter connector.
| 4. INSTALL THROTTLE BODY |
| 5. INSPECT FOR FUEL LEAK (for Fuel Sub Tank) |
Start the engine.
Check for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.