ECD SYSTEM (w/ EGR Cooler) > Pre-heating Control Circuit |



| 1.INSPECT GLOW RELAY |
Inspect the glow plug relay (GLOW) (Click here).
|
| ||||
| OK | |
| 2.INSPECT GLOW PLUG ASSEMBLY (RESISTANCE) |
Inspect the glow plug (Click here).
|
| ||||
| OK | |
| 3.CHECK GLOW PLUG ASSEMBLY (INSTALLATION) |
Check the glow plug installation.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (GLOW RELAY - ECM AND BODY GROUND) |
Disconnect the ECM connector.
Remove the GLOW relay from the engine room relay block and junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E4-15 (GREL) - GLOW relay (2) | Always | Below 1 Ω |
| GLOW relay (1) - Body ground | Always | Below 1 Ω |
| E4-15 (GREL) or GLOW relay (2) - Body ground | Always | 10 kΩ or higher |
Reinstall the GLOW relay.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (GLOW RELAY - GLOW PLUG AND BATTERY) |
Remove the GLOW relay from the engine room relay block and junction block assembly.
Disconnect the glow plug connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| GLOW relay (3) - G1-1 | Always | Below 1 Ω |
| GLOW relay (5) - Positive (+) battery terminal cable | Always | Below 1 Ω |
| GLOW relay (3) or G1-1 - Body ground | Always | Below 1 Ω |
Reinstall the GLOW relay.
Reconnect the glow plug connector.
|
| ||||
| OK | |
| 6.CHECK ECM (BATT VOLTAGE) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E5-2 (BATT) - E6-7 (E1) | Always | 11 to 14 V |
| *a | Component with harness connected (ECM) |
|
| ||||
| OK | |
| 7.CHECK ECM (GREL VOLTAGE) |
![]() |
Start the engine.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E4-15 (GREL) - E6-7 (E1) | Engine coolant temperature 40°C (104°F) or less | 11 to 14 V |
| *a | Component with harness connected (ECM) |
|
| ||||
| OK | ||
| ||