DTC C1425 Open in Stop Light Switch Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1425 | When the IG1 terminal voltage is between 9.5 and 17.4 V, an open in the stop light switch circuit continues for 0.3 seconds or more. |
|

| 1.CHECK STOP LIGHT OPERATION |
Check that the stop light LH and RH come on when the brake pedal is depressed, and go off when the brake pedal is released.
| Condition | Illumination Condition |
| Brake pedal depressed | On |
| Brake pedal released | Off |
|
| ||||
| OK | |
| 2.CHECK TERMINAL VOLTAGE (STP TERMINAL) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-2 (STP) - Body ground | Brake pedal depressed | 8 to 14 V |
| Brake pedal released | Below 1.5 V |
| *a | Front view of wire harness connector (to Skid Control ECU [Brake Actuator Assembly]) |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Depress the brake pedal.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||