DTC C1427 Motor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1427 | The pump motor does not operate properly. |
|
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | Motor relay | Relay ON / OFF | The operating sound of the motor can be heard. |
Check the operating sound of the motor relay when operating the motor relay with the intelligent tester.
| Result | Proceed to |
| Operating sound is not heard | A |
| Operating sound is heard | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-13 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||