DTC C1422 Master Cylinder Pressure Sensor Zero Point High Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1422 | When the stop light switch is off, the PMC terminal voltage is higher than 0.86 V for 5 seconds or more. |
|

| 1.CHECK DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more and perform a braking test (decelerate the vehicle by depressing the brake pedal).
Check for DTCs (Click here).
| Result | Proceed to |
| DTC C1422 is output | A |
| DTC C1422 and C1425 are output | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SW) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
Check that the stop light switch display observed on the intelligent tester changes according to the brake pedal operation.
|
| ||||
| OK | |
| 3.CHECK BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION |
Turn the ignition switch off.
Check the brake pedal height and stop light switch installation (Click here).
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more and perform a braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1422 is not output | A |
| DTC C1422 is output | B |
|
| ||||
| A | ||
| ||
| 5.CHECK TERMINAL VOLTAGE (STOP LIGHT POWER SOURCE CIRCUIT) |
Turn the ignition switch off.
Disconnect the stop light switch assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S14-2 - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Stop Light Switch Assembly) |
|
| ||||
| OK | |
| 6.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Turn the ignition switch off.
Remove the stop light switch assembly (Click here).
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 7.CHECK TERMINAL VOLTAGE (STP TERMINAL) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-2 (STP) - Body ground | Brake pedal depressed | 8 to 14 V |
| Brake pedal released | Below 1.5 V |
| *a | Front view of wire harness connector (to Skid Control ECU [Brake Actuator Assembly]) |
|
| ||||
| OK | ||
| ||