FUEL INJECTOR > INSPECTION |
| 1. INSPECT FUEL INJECTOR ASSEMBLY |
Measure the resistance between the terminals.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 11.6 to 12.4 Ω |
| 2. INSPECT INJECTION VOLUME AND LEAKAGE |
Check the injection volume.
Discharge the fuel system pressure (Click here).
Remove the fuel hose from the fuel pressure pulsation damper (Click here).
Remove the fuel hose from the fuel filter (Click here).
Disconnect the fuel pressure regulator (Click here).
Assemble SST as shown in the illustration.

![]() |
Connect SST to the fuel filter.
![]() |
Connect SST to the pressure regulator fuel inlet with the 2 bolts.
Install the O-ring to the fuel injector.
![]() |
Assemble SST as shown in the illustration.
Put the injector into a graduated cylinder.
Operate the fuel pump.
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.
Check the fuel leakage.
In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the injector.