Home › ENGINE ยท 2TR-FBE › FUEL › FUEL FILTER

FUEL FILTER > REPLACEMENT

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


2. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE FUEL FILTER ASSEMBLY


    A237748
  1. Disconnect the No. 1 fuel hose (Click here).

    NOTICE:
    1. Check for dirt or mud contamination in the fuel hose and around the connector of the fuel hose. Clean if necessary. Dirt or mud can affect the ability of the O-ring to seal the connector and the upper pipe of the fuel filter.
    2. Do not use tools to separate the connector and upper pipe.
    3. Do not forcefully bend or twist the hose.
    4. Keep the connector and pipe free from foreign matter.
    5. Put the connector in a plastic bag to prevent damage and contamination.
    6. If the connector and upper pipe are stuck together, pinch the connector and turn it carefully to disconnect it.



    A237749E01
  1. Disconnect the fuel filter from the bracket, and then disconnect the fuel main tube (Click here) and remove the fuel filter.

    NOTICE:
    1. Check for dirt or mud contamination in the fuel hose and around the connector of the fuel hose. Clean if necessary. Dirt or mud can affect the ability of the O-ring to seal the connector and the lower pipe of the fuel filter.
    2. Do not use tools to separate the connector and lower pipe.
    3. Do not forcefully bend or twist the hose.
    4. Keep the connector and pipe free from foreign matter.
    5. Put the connector in a plastic bag to prevent damage and contamination.
    6. If the connector and lower pipe are stuck together, pinch the connector and turn it carefully to disconnect it.



5. INSTALL FUEL FILTER ASSEMBLY
  1. Connect the fuel main tube to the fuel filter (Click here), and then connect the fuel filter to the bracket.

    NOTICE:
    Before installing the connector of the fuel main tube to the lower pipe of the fuel filter, check the connector for damage and foreign matter.

  1. Connect the No. 1 fuel hose (Click here).

    NOTICE:
    Before installing the connector of the fuel hose to the upper pipe of the fuel filter, check the connector for damage and foreign matter.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. INSPECT FOR FUEL LEAK (for Fuel Main Tank)
  1. Connect the intelligent tester to the DLC3.

    1. Turn the ignition switch to ON.

      NOTICE:
      Do not start the engine.

    2. Push the intelligent tester main switch on.

    3. Select the Active Test and enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks after performing maintenance anywhere on the fuel system.
      If there are fuel leaks, repair or replace parts as necessary.