Home › ENGINE ยท 2TR-FBE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloration or thinning.
    If the quality is visibly poor, replace the oil and oil filter (Click here).



2. INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, and then stop the engine and wait for 5 minutes.
    If the oil level is low, check for leakage and add oil up to the full level mark.

  1. Check that the engine oil level is between the low level and full level marks on the dipstick.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.



3. INSPECT OIL PRESSURE


    A086844E04
  1. Disconnect the oil pressure switch connector.

  1. Remove the oil pressure switch.

  1. Install an oil pressure gauge.

  1. Warm up the engine.

  1. Check the oil pressure under the following conditions.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
    3000 rpm
    160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi)

  1. Remove the oil pressure gauge.

  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    NOTICE:
    Do not apply adhesive to the oil inlet port of the oil pressure switch.

  1. Install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation of the switch.

  1. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.