DTC C1437 Lost Communication with ECM |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1437 | When the IG1 terminal voltage is 10 V or higher and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent from the ECM for 2 seconds or more. |
|
| 1.CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) |
Using the intelligent tester, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| EFI Communication Open | ECM communication open circuit detection / Error or Normal | Normal | - |
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1437 is not output | A |
| DTC C1437 is output | B |
| CAN communication system DTC is output | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.REPAIR OR REPLACE HARNESS OR CONNECTOR (SKID CONTROL ECU - ECM) |
Turn the ignition switch off.
Repair or replace the harness or connector.
Check for any momentary interruption between the skid control ECU (brake actuator assembly) and ECM (Click here).
Confirm that there is no momentary interruption.
| NEXT | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1437 is not output | A |
| DTC C1437 is output | B |
| CAN communication system DTC is output | C |
|
| ||||
|
| ||||
| A | ||
| ||