Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR (w/ VSC)

BRAKE ACTUATOR (w/ VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE BRAKE ACTUATOR ASSEMBLY


    C194677E02
  1. Use tags or mark a note to identify the reconnection locations.

    HINT:
    1. *1: to front wheel cylinder RH
    2. *2: to front wheel cylinder LH
    3. *3: to rear wheel cylinder RH
    4. *4: to rear wheel cylinder LH
    5. *5: from master cylinder



    C242470
  1. Release the latch of the actuator connector and disconnect the connector.

  1. Using a union nut wrench, disconnect the 6 brake lines from the actuator.



    C194679
  1. Remove the 2 bolts, nut and actuator with bracket.

    NOTICE:
    Be careful not to damage the brake tubes.



4. REMOVE NO. 3 BRAKE ACTUATOR BRACKET


    C194683E02
  1. Remove the bolt and No. 3 brake actuator bracket.