Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING


C113161
  1. Install the shock absorber on the body so that the lower end of the coil spring faces the rear of the vehicle.



    C288512E01
  1. Using SST, install the 3 nuts to the upper side of the front shock absorber with coil spring.

    SST
    09249-B1010  
    Text in Illustration 
    *a
    Fulcrum Length

    Torque:
    without SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }
    with SST:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).



    F049985E02
  1. Temporarily install the bolt and nut as shown in the illustration.

    HINT:
    Fix the nut in place and temporarily install the bolt.



2. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the stabilizer link to the steering knuckle with the nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



3. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



4. INSTALL FRONT WHEEL

Torque:
105 N*m{ 1071 kgf*cm , 77 ft.*lbf }



5. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



6. TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
  1. Fix the nut in place and tighten the bolt.

    Torque:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }

    NOTICE:
    Do not tighten the nut.



7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
  1. Inspect and adjust the front wheel alignment (Click here).