STEERING KNUCKLE > INSTALLATION |
| 1. INSTALL FRONT AXLE HUB ASSEMBLY |
![]() |
Apply MP grease to a new O-ring.
Install the new O-ring to the axle hub.
Install the dust cover and axle hub to the steering knuckle with the 4 bolts.
| 2. INSTALL FRONT AXLE HUB DUST SEAL (for 4WD) |
![]() |
Using SST and a press, press in a new dust seal.
| 3. INSTALL KNUCKLE GREASE RETAINER CAP LH (for Pre-Runner) |
![]() |
Using a brass bar and hammer, install a new retainer cap.
| 4. INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH |
![]() |
Install the upper arm with the nut.
Install a new cotter pin.
| 5. INSTALL FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH |
![]() |
Install the suspension arm with the 2 bolts.
| 6. INSTALL TIE ROD END SUB-ASSEMBLY LH |
![]() |
Install the tie rod end with the nut.
Install a new cotter pin.
| 7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Install the stabilizer link with the nut.
| 8. INSTALL FRONT AXLE HUB NUT |
![]() |
Install the hub nut.
Install the adjusting cap and a new cotter pin.
| 9. INSTALL FRONT AXLE HUB GREASE CAP |
Install a new grease cap to the axle hub.
| 10. INSTALL FRONT DISC |
| 11. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH |
![]() |
Install the disc brake caliper with the 2 bolts.
![]() |
Install the brake tube bracket to the steering knuckle with the bolt.
![]() |
Using SST, connect the brake tube to the disc brake caliper.
| 12. INSTALL SPEED SENSOR FRONT LH |
![]() |
Install the speed sensor with the bolt.
Connect the 2 clamps.
Install the speed sensor wire harness to the steering knuckle with the bolt.
| 13. BLEED BRAKE LINE |
w/ VSC:
(Click here)
w/o VSC:
(Click here)
| 14. INSTALL FRONT WHEEL |
| 15. CHECK ABS SPEED SENSOR SIGNAL |
w/ VSC:
(Click here )
w/o VSC:
(Click here)