Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM


C240177E25


INSPECTION PROCEDURE

1.CHECK PARKING BRAKE SWITCH ASSEMBLY


    E278090
  1. Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Touch Switch in Operation Check (Click here)]

  1. Check that the display changes between ON and OFF according to the parking brake operation.

    OK:
    Parking Brake Condition
    Display
    Applied
    ON
    Released
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
  1. Disconnect the R21 radio and display receiver assembly connector.

  1. Disconnect the P3 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R21-15 (PKB) - P3-1
    Always
    Below 1 Ω
    R21-15 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    C217121
  1. Remove the parking brake switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Switch connector - Switch body
    On (Shaft is not pressed)
    Below 1 Ω
    Off (Shaft is pressed)
    10 kΩ or higher
    Text in Illustration 
    V100135
    On
    V100136
    Off



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)