Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Manual Seat)

FRONT SEAT INNER BELT ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)


B113100E01
  1. w/ Passenger seat belt warning light:
    Attach the 2 clamps as shown in the illustration.

  1. w/ Passenger seat belt warning light:
    Connect the connector.



    B113101E01
  1. Install the buckle cover on the inner belt.



    B084928E01
  1. w/ Passenger seat belt warning light:
    Attach the wire harness to the clamp.

  1. Install the seat belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not overlap the anchor part of the seat belt and protruding part of the seat adjuster.



2. INSTALL FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


B120318
  1. Install the buckle cover on the seat belt.



    B087821E01
  1. Install the seat belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not overlap the anchor part of the seat belt and protruding part of the seat adjuster.

  1. Attach the wire harness to the clamp.



    B087811E01
  1. Attach the clamp as shown in the illustration.



3. INSTALL FRONT SEAT ASSEMBLY (for Driver Side)
(Click here)


4. INSTALL FRONT SEAT ASSEMBLY (for Front Passenger Side)
(Click here)


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.