Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
(Click here)


2. REMOVE AUTOMATIC TRANSMISSION (for Automatic Transmission)
(Click here)


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


D029616E03
  1. Place matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.



5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    A072851E02
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-58014  
    09330-00021  



    A114803
  1. Remove the 8 bolts and flywheel.



6. REMOVE PUMP IMPELLER DRIVE PLATE (for Automatic Transmission)


    A072851E02
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-58014  
    09330-00021  



    A114804
  1. Remove the 8 bolts, the rear drive plate spacer, the pump impeller drive plate, and the flywheel.



7. REMOVE REAR CRANKSHAFT OIL SEAL


    A251990E01
  1. Using a knife, cut off the lip of the rear crankshaft oil seal.
    Text in Illustration 
    *1
    Cut Position

  1. Using a screwdriver, pry out the rear crankshaft oil seal.

    NOTICE:
    Be careful not to damage the crankshaft.