AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Steering Pad Switch Circuit |

| 1.INSPECT STEERING PAD SWITCH ASSEMBLY |
Remove the steering pad switch assembly (Click here).
Inspect the steering pad switch assembly (Click here).
|
| ||||
| OK | |
| 2.INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Remove the spiral cable sub-assembly (Click here).
Inspect the spiral cable sub-assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the S28 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R21-21 (SW1) - S28-6 (AU1) | Always | Below 1 Ω |
| R21-22 (SW2) - S28-5 (AU2) | ||
| R21-23 (SWG) - S28-4 (EAU) | ||
| R21-21 (SW1) - Body ground | Always | 10 kΩ or higher |
| R21-22 (SW2) - Body ground | ||
| R21-23 (SWG) - Body ground |
|
| ||||
| OK | ||
| ||