P0418
| - After a cold engine start, all conditions are met (2 trip detection logic):
- Air Injection (AIR) system is not operating (air pump off, air switching valve off).
- Diagnostic signal from the air injection control driver is 20%.
- Battery voltage is 8 V or higher.
| - Open in air pump drive circuit (air injection control driver - air pump assembly) or short between air pump drive circuit and +B or BATT
- Open in air injection control driver BATT circuit (air injection control driver power source)
- Harness and connector (air injection control driver - air pump assembly)
- Air pump assembly
- Air injection control driver
- ECM
|
P0418
| - After a cold engine start, all conditions are met (2 trip detection logic):
- Air Injection (AIR) system is operating (air pump on, air switching valve on).
- Diagnostic signal from the air injection control driver is 20%.
- Battery voltage is 8 V or higher.
| - Short between air pump drive circuit and body ground
- Open or in air injection control driver BATT circuit (air injection control driver power source)
- Harness and connector (air injection control driver - air pump assembly)
- Air pump assembly
- Air injection control driver
- ECM
|