Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (for i-ART)

ECD SYSTEM (for i-ART) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT GTS TO DLC3

        HINT:
        If the display indicates a communication fault in the GTS, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*
      1. Check for DTCs (Click here) and freeze frame data (Click here).

        HINT:
        Record or print DTCs and freeze frame data if necessary.


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*
      1. Clear DTCs and freeze frame data (Click here).


      NEXT


      6.VISUAL INSPECTION

        NEXT


        7.CONFIRM PROBLEM SYMPTOMS

          HINT:
          If the engine does not start, first perform the "Check DTC" and "Basic Inspection" procedures below.

          Result 
          Result
          Proceed to
          Malfunction occurs
          A
          Malfunction does not occur
          B


        B.
        SIMULATE SYMPTOMS
        A


        8.CHECK DTC*

          HINT:
          Refer to DTC Check / Clear (Click here).

          Result 
          Result
          Proceed to
          Trouble code
          A
          No trouble code
          B


        B.
        Go to step 9
        A

        REFER TO DTC CHART


        9.CONDUCT BASIC INSPECTION
        1. Conduct basic inspection (Click here).

        2. Result 
          Result
          Proceed to
          Malfunctioning parts not confirmed
          A
          Malfunctioning parts confirmed
          B


        B.
        Go to step 11
        A


        10.REFER TO PROBLEM SYMPTOMS TABLE

          HINT:
          1. Refer to Problem Symptoms Table (Click here).
          2. Also, refer to the inspection procedure for the problem symptom.


        NEXT


        11.PARTS INSPECTION

          NEXT


          12.IDENTIFY PROBLEM

            NEXT


            13.ADJUST AND/OR REPAIR

              NEXT


              14.CONFIRMATION TEST

                NEXT

                END