DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 | When either condition below is met:
|
|
| P0339 | No crankshaft position sensor signal to ECM is input for 0.05 seconds or more, and conditions (a), (b) and (c) are met (1 trip detection logic):
|
|

| 1.INSPECT CRANKSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C5 sensor connector.
Measure the resistance of the sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Cold | 1,630 to 2,740 Ω |
| 1 - 2 | Hot | 2,065 to 3,225 Ω |
![]() |
| Tester Connection | Specified Condition |
| E6-23 (G+) - E6-31 (G-) E7-27 (NE+) - E7-34 (NE-) | Correct waveform is shown |
| Tool Setting | Condition |
| 5 V/DIV., 20 msec./DIV. | Idling with warm engine |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C5 sensor connector.
Disconnect the E7 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C5-1 - E7-27 (NE+) | Below 1 Ω |
| C5-2 - E7-34 (NE-) | Below 1 Ω |
| C5-1 or E7-27 (NE+) - Body ground | 10 kΩ or higher |
| C5-2 or E7-34 (NE-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CRANKSHAFT POSITION SENSOR (INSTALLATION) |
![]() |
Check the sensor installation.
|
| ||||
| OK | |
| 4.CHECK CRANKSHAFT POSITION SENSOR NO. 1 PLATE |
Check the teeth of the crankshaft position sensor No. 1 plate.
|
| ||||
| OK | ||
| ||
| 5.INSPECT CAMSHAFT TIMING PULLEY |
Check the teeth of the camshaft timing pulley.
|
| ||||
| OK | ||
| ||