Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for 2.2 kW Type Bosch Made)

STARTER (for 2.2 kW Type Bosch Made) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.



5. REMOVE STARTER ASSEMBLY


    A201713
  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A201714E01
  1. Remove the 2 bolts and disconnect the ground cable.

  1. Remove the starter.