Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECM (w/ Glow Plug Controller)

ECM (w/ Glow Plug Controller) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



2. INSTALL NO. 1 ECM BRACKET
  1. Install the No. 1 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



3. INSTALL ECM
  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 6 connectors.



4. INSTALL TRANSMISSION CONTROL ECU


    A111797
  1. Install the TCM with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 3 connectors.



5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY



6. PERFORM REGISTRATION
  1. Perform registration (Click here).

    HINT:
    Only perform registration when the ECM is replaced, either by itself or in any of the following combinations.
    1. ECM and Fuel Supply Pump
    2. ECM and Diesel Throttle Body Assembly
    3. ECM and Injector Assembly
    4. ECM and Engine Assembly



7. START ENGINE
  1. When replacing the ECM, start the engine to initialize the new ECM (Click here).