REAR VIEW MONITOR SYSTEM (for Navigation Receiver Type) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.CHECK DTC OF NAVIGATION SYSTEM |
Refer to DTC Check/Clear procedures of the navigation system (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
| Symptom does not occur | A |
| Symptom occurs | B |
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM |
Refer to the navigation system (Click here).
| Result | Proceed to |
| Symptom does not appear | A |
| Symptom appears | B |
|
| ||||
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
Refer to the problem symptoms table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW |
Terminals of ECU (Click here).
| |||||
| 9.ADJUST, REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|