Home › ENGINE ยท 1KD-FTV › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A099591E01
  1. Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112147E01



3. REMOVE AIR CLEANER ASSEMBLY


A099628E02
  1. Disconnect the mass air flow meter connector and remove the clamp.

  1. Loosen the hose clamp of the compressor inlet elbow.

  1. Remove the 2 bolts and air cleaner.



4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A211905E01
  1. Remove the 3 bolts, 2 cap nuts and No. 1 engine cover.



5. REMOVE CHARGE AIR COOLER ASSEMBLY
  1. Remove the charge air cooler (Click here).



6. REMOVE COMPRESSOR INLET ELBOW


A110341
  1. Remove the bolt from the ventilation pipe.

  1. Move the clamp so that the hose can be disconnected.

  1. Disconnect the ventilation pipe from the cylinder head cover.

  1. Disconnect the 2 connectors from the turbocharger.

  1. Remove the wire clamp's clip from the inlet elbow.

  1. Remove the 2 nuts, inlet elbow and gasket.



7. DISCONNECT RADIATOR HOSE INLET
  1. Disconnect the hose from the water inlet.



8. REMOVE NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)


A097634E01
  1. Remove the bolt and disconnect the clamp.



9. REMOVE WATER INLET


A097637E01
  1. Remove the 3 bolts and inlet.



10. REMOVE THERMOSTAT