WATER PUMP > INSTALLATION |
| 1. INSTALL ENGINE WATER PUMP ASSEMBLY |
![]() |
Install a new gasket and the engine water pump with the 10 bolts.
| 2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY |
![]() |
Temporarily install the belt tensioner with the 3 bolts.
Install the tensioner with the 3 bolts.
| 3. INSTALL NO. 1 IDLER PULLEY SUB-ASSEMBLY |
![]() |
Install the spacer and pulley with the bolt.
| 4. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE |
Apply a light coat of engine oil to a new O-ring.
Install a new O-ring to the engine oil level dipstick guide.
Install the engine oil level dipstick guide with the bolt.
Install the engine oil level dipstick.
| 5. INSTALL GENERATOR ASSEMBLY |
| 6. INSTALL FAN SHROUD |
![]() |
Install the fan pulley to the engine water pump.
Place the shroud together with the fluid coupling fan between the radiator and engine.
Install the coupling fan to the water pump with the 4 nuts. Tighten the nuts as much as possible by hand.
Attach the shroud's claws to the radiator as shown in A in the illustration.
Install the fan shroud with the 2 bolts.
Connect the reservoir hose to the radiator tank upper.
Install the drive belt (Click here).
Tighten the 4 nuts of the fluid coupling fan.
| 7. CONNECT AIR PUMP INLET |
Connect the air pump inlet to the radiator with the bolt.
| 8. CONNECT RADIATOR HOSE OUTLET |
Connect the radiator hose outlet to the radiator.
| 9. CONNECT RADIATOR HOSE INLET |
Connect the radiator hose inlet to the radiator.
| 10. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
| Item | Specified Condition |
| A/T | 8.1 liters (8.6 US qts, 7.1 Imp. qts) |
| M/T | 7.8 liters (8.2 US qts, 6.9 Imp. qts) |
Fill the radiator reservoir with TOYOTA SLLC to the F line.
Press the inlet and outlet radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level drops below the F line, add TOYOTA SLLC to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens.
While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2500 to 3000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC up to the reservoir F line.
| 11. INSPECT FOR COOLANT LEAK |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the cylinder block and cylinder head.
| 12. INSTALL NO. 1 ENGINE UNDER COVER |