Home › ENGINE ยท 2TR-FBE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE RADIATOR GRILLE
(Click here)


4. REMOVE RADIATOR SIDE DEFLECTOR LH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



5. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



6. REMOVE NO. 1 ENGINE UNDER COVER


7. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.

    CAUTION:
    Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the cylinder block drain cock plug and radiator drain cock plug to drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A263383E01



8. DISCONNECT RADIATOR HOSE INLET
  1. Disconnect the radiator hose inlet from the radiator.



9. DISCONNECT RADIATOR HOSE OUTLET
  1. Disconnect the radiator hose outlet from the radiator.



10. DISCONNECT AIR PUMP INLET


    A099954E02
  1. Remove the bolt and disconnect the air pump inlet from the radiator.



11. REMOVE FAN SHROUD


A099963E02
  1. Disconnect the reservoir hose from the radiator.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts holding the fluid coupling fan, and then remove the fan shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the engine water pump.



12. DISCONNECT OIL COOLER INLET HOSE (for Automatic Transmission)
  1. Disconnect the oil cooler inlet hose from the radiator.



13. DISCONNECT OIL COOLER OUTLET HOSE (for Automatic Transmission)
  1. Disconnect the oil cooler outlet hose from the radiator.



14. REMOVE RADIATOR ASSEMBLY


    A110375
  1. w/ Airbag System:

    1. Using a clip remover, detach the 4 clamps from the radiator as shown in the illustration.

      HINT:
      Tape the clip remover tip before use.



    A099640E01
  1. Remove the 4 bolts and radiator.