CYLINDER HEAD GASKET > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and drain plug.
Install a new gasket and the oil pan drain plug.
| 4. REMOVE INTAKE MANIFOLD |
| 5. REMOVE GLOW PLUG ASSEMBLY |
| 6. REMOVE INJECTOR ASSEMBLY |
| 7. REMOVE COMMON RAIL ASSEMBLY |
| 8. REMOVE FAN SHROUD |
| 9. REMOVE TURBOCHARGER SUB-ASSEMBLY |
| 10. DISCONNECT COOLER COMPRESSOR ASSEMBLY |
Remove the 4 bolts and disconnect the cooler compressor.
| 11. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET |
Remove the 4 bolts and No. 1 compressor mounting bracket.
| 12. REMOVE EXHAUST MANIFOLD |
![]() |
Remove the 8 nuts, 8 plate washers, 8 collars and exhaust manifold.
| 13. REMOVE TIMING BELT |
| 14. REMOVE CAMSHAFT TIMING PULLEY |
![]() |
Remove the bolt of the camshaft timing pulley while holding the camshaft with a wrench.
Remove the camshaft timing pulley.
| 15. REMOVE NO. 2 TIMING BELT COVER |
Remove the 4 bolts, nut and timing belt cover.
| 16. REMOVE CAMSHAFT |
![]() |
Turn the camshaft with a wrench so that the key groove of the camshaft faces upward.
| *1 | Key Groove |
![]() |
Uniformly loosen the 15 bearing cap bolts in several passes in the sequence shown in the illustration.
Remove the 15 bearing cap bolts, 5 bearing caps, oil seal and 2 camshafts.
| 17. REMOVE VALVE LIFTER |
Remove the valve lifters.
| 18. REMOVE CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Uniformly loosen the 18 cylinder head bolts in several passes in the sequence shown in the illustration. Then remove the 18 cylinder head bolts and 18 washers.
Lift the cylinder head from the dowels on the cylinder block, and place the cylinder head on wooden blocks on a bench.
| 19. REMOVE CYLINDER HEAD GASKET |