FUEL PRESSURE REGULATOR > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the fuel pump connector.
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.
Crank the engine again, and check that the engine does not start.
Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.
Connect the fuel pump connector.
| 2. PRECAUTION |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE V-BANK COVER |
Remove the 2 nuts and cover.
| 5. REMOVE NO. 2 VENTILATION HOSE |
![]() |
| 6. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Disconnect the vacuum hose.
Disconnect the MAF meter connector.
Remove the 2 wire harness clamps.
![]() |
Loosen the 2 hose clamps.
Remove the 2 bolts and air cleaner.
| 7. REMOVE INTAKE AIR SURGE TANK |
![]() |
Disconnect the 2 water by-pass hose.
![]() |
Disconnect the purge line hose.
![]() |
Disconnect the ventilation hose.
![]() |
Disconnect the 2 VSV connectors.
Disconnect the throttle body with motor connector.
Separate the 3 wire harness clamps and hose clamp.
![]() |
Remove the 2 bolts and throttle body bracket.
![]() |
Remove the bolt and oil baffle plate.
Remove the 4 bolts and 2 surge tank stays.
![]() |
Remove the 2 nuts.
Using an 8 mm hexagon socket wrench, remove the 4 bolts, intake air surge tank and gasket.
| 8. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY |
![]() |
Remove the fuel pipe clamp.
Pinch the tube connector and then pull out the fuel pipe.

| 9. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Remove the 2 bolts and fuel pressure regulator.
Remove the vacuum hose.