FUEL SUPPLY PUMP (w/ Glow Plug Controller) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE RADIATOR ASSEMBLY |
| 4. REMOVE TIMING BELT |
| 5. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER |
| 6. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt, nut and 2 No. 2 injection pipe clamps.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.
| 7. REMOVE WIRING HARNESS CLAMP BRACKET |
![]() |
Detach the wire harness clamp.
| *1 | Wiring Harness Clamp Bracket |
Remove the bolt and wiring harness clamp bracket.
| 8. REMOVE NO. 2 FUEL PIPE |
![]() |
Using a 6 mm hexagon wrench, remove the supply pump hollow screw and gasket.
![]() | Supply Pump Hollow Screw |
![]() | Fuel Check Valve |
Remove the fuel check valve, No. 2 fuel pipe and gasket.
| 9. REMOVE FUEL SUPPLY PUMP ASSEMBLY |
Disconnect the 2 fuel hoses.
Disconnect the suction control valve connector from the fuel supply pump.
![]() |
Remove the 4 bolts indicated by the arrows in the illustration.
Remove the No. 2 camshaft timing pulley flange and pump drive shaft pulley.
![]() |
Remove the set nut and O-ring while holding the crankshaft pulley using SST.
![]() |
Loosen the 2 nuts.
![]() |
Using SST, disconnect the fuel supply pump from the injection gear.
Remove the 2 nuts and fuel supply pump.
Remove the O-ring.