Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV with i-ART)

AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV with i-ART) > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

When the ignition switch is turned to ON, battery voltage is applied to terminal IG2 of the TCM.

WIRING DIAGRAM


C190897E11


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT IGNITION SWITCH


    C241948E01
  1. Disconnect the ignition switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (AM2) - 6 (IG2)
    LOCK
    10 kΩ or higher
    5 (AM2) - 6 (IG2)
    ON
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Ignition Switch)



NG
REPLACE IGNITION SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND)


    C212047E73
  1. Disconnect the TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to TCM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TCM (TCM - BATTERY)
  1. Turn the ignition switch to ON.



    C212050E18
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    T35-6 (IG2) - T19-1 (E1)
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to TCM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM (Click here)