DTC B15C2 Speed Signal Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15C2 | A difference between the GPS speed and SPD pulse is detected. |
|

| 1.CHECK VEHICLE SENSOR (OPERATION CHECK) |
![]() |
Enter the "System Sensors Check" screen. Refer to Check GPS & Vehicle Sensors in Operation Check (Click here).
While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.
|
| ||||
| OK | ||
| ||
| 2.CHECK COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
![]() |
Check the output waveform.
Remove the combination meter assembly with the connector(s) still connected (Click here).
Connect an oscilloscope to terminal C26-6 and body ground.
Turn the ignition switch to ON.
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Measurement terminal | C26-6 - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Wheel being rotated |
| *a | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY) |
Disconnect the N5 navigation receiver assembly connector.
Disconnect the C26 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N5-17 (SPD) - C26-6 | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||