DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Crank engine for 4 seconds (STA on) | STA on: No camshaft position sensor signal is sent to the ECM while cranking for 4 seconds or more (2 trip detection logic) |
|
| Idle engine for 1 second (STA off) | STA off: Either condition is met (1 trip detection logic):
|
| 1.INSPECT CAMSHAFT POSITION SENSOR |
Inspect the camshaft position sensor (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
Disconnect the camshaft position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C1-1 - E27-13 (G+) | Always | Below 1 Ω |
| C1-2 - E27-14 (G-) | Always | Below 1 Ω |
| C1-1 or E27-13 (G+) - Body ground | Always | 10 kΩ or higher |
| C1-2 or E27-14 (G-) - Body ground | Always | 10 kΩ or higher |
Reconnect the camshaft position sensor connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 3.CHECK CAMSHAFT POSITION SENSOR (SENSOR INSTALLATION) |
![]() |
Check the sensor installation.
|
| ||||
| OK | |
| 4.CHECK CAMSHAFT TIMING PULLEY |
Check the condition of the camshaft timing pulley.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR CIRCUIT) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs (Click here).
Turn the ignition switch off and wait for 30 seconds or more.
Start the engine and idle it for 4 seconds or more.
Turn the GTS on.
Check the engine condition while wiggling the crankshaft position sensor wire harness for 4 seconds or more when idling.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| Except below | A |
| There are problems such as rough idle or engine stall when wire harness is wiggled, or DTC is output* | B |
|
| ||||
| A | |
| 6.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 7.REPLACE CAMSHAFT POSITION SENSOR |
Replace the camshaft position sensor (Click here).
|
| ||||
| 8.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
|
| ||||
| 9.SECURELY REINSTALL SENSOR |
Securely reinstall the sensor (Click here).
|
| ||||
| 10.REPLACE CAMSHAFT TIMING PULLEY |
Replace the camshaft timing pulley (Click here).
| NEXT | |
| 11.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the GTS to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Start the engine and idle it for 4 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| NEXT | ||
| ||