DTC P0122 Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input |
DTC P0123 Throttle / Pedal Position Sensor / Switch "A" Circuit High Input |

| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 3 seconds | Throttle position sensor output (VLU) is below 0.2 V for 3 seconds (1 trip detection logic). |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 3 seconds | Throttle position sensor output (VLU) is higher than 4.8 V for 3 seconds (1 trip detection logic). |
|


| 1.CHECK HARNESS AND CONNECTOR (THROTTLE POSITION SENSOR - ECM) |
Disconnect the throttle position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T3-1 (VC) - E7-18 (VC) | Always | Below 1 Ω |
| T3-3 (VTA) - E6-29 (VLU) | Always | Below 1 Ω |
| T3-2 (E2) - E7-28 (E2) | Always | Below 1 Ω |
| T3-1 (VC) or E7-18 (VC) - Body ground | Always | 10 kΩ or higher |
| T3-3 (VTA) or E6-29 (VLU) - Body ground | Always | 10 kΩ or higher |
Reconnect the throttle position sensor connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 2.CHECK ECM TERMINAL VOLTAGE (VC TERMINAL) |
![]() |
Disconnect the throttle position sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| T3-1 (VC) - T3-2 (E2) | Ignition switch ON | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to Throttle Position Sensor) |
Reconnect the throttle position sensor connector.
|
| ||||
| OK | |
| 3.REPLACE DIESEL THROTTLE BODY ASSEMBLY |
Replace the diesel throttle body assembly (Click here).
| NEXT | |
| 4.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Clear the DTCs (Click here).
Enter the following menus: Powertrain / Engine and ECT / Data List / Actual Throttle position.
Check the movement of the throttle valve when idling the engine after starting it from ignition switch to ON.
| Condition | Tester Display |
| Ignition switch ON | -5 to 5% |
| Idling | 0 to 90% |
|
| ||||
| OK | ||
| ||
| 5.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs (Click here).
Turn the ignition switch off and wait for 30 seconds or more.
Turn the ignition switch to ON for 3 seconds.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||