DTC P0405 Exhaust Gas Recirculation Sensor "A" Circuit Low |
DTC P0406 Exhaust Gas Recirculation Sensor "A" Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 5 seconds or more | EGR valve position sensor output voltage is less than 0.2 V for 2 seconds. (1 trip detection logic) |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch ON for 5 seconds or more | EGR valve position sensor output voltage is higher than 4.8 V for 2 seconds. (1 trip detection logic) |
|
| 1.CHECK HARNESS AND CONNECTOR (EGR VALVE POSITION SENSOR - ECM) |
Disconnect the electric EGR control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E33-3 (VC) - E29-13 (VCEG) | Always | Below 1 Ω |
| E33-2 (VTA) - E29-7 (EGRA) | Always | Below 1 Ω |
| E33-1 (E2) - E29-1 (EEGL) | Always | Below 1 Ω |
| E33-3 (VC) or E29-13 (VCEG) - Body ground | Always | 10 kΩ or higher |
| E33-2 (VTA) or E29-7 (EGRA) - Body ground | Always | 10 kΩ or higher |
Reconnect the electric EGR control valve assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE) |
![]() |
Disconnect the electric EGR control valve assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E33-3 (VC) - E33-1 (E2) | Ignition switch ON | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to Electric EGR Valve Assembly) |
Reconnect the electric EGR control valve assembly connector.
|
| ||||
| OK | |
| 3.REPLACE ELECTRIC EGR CONTROL VALVE ASSEMBLY |
Replace the electric EGR control valve assembly (Click here).
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (P0405 OR P0406) |
Connect the GTS to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch to ON for 5 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
|
| ||||
| NG | |
| 5.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the GTS to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch to ON for 5 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| NEXT | ||
| ||