Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    P2226    Barometric Pressure Circuit

DTC    P2228    Barometric Pressure Circuit Low Input

DTC    P2229    Barometric Pressure Circuit High Input

for Preparation Click here


DESCRIPTION

To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.

P2226 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch to ON for 1 second
Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds (1 trip detection logic).
ECM

P2228 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch to ON for 1 second
Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds (1 trip detection logic).
ECM

P2229 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch to ON for 1 second
Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds (1 trip detection logic).
ECM

Related Data List 
DTC No.
Data List
P2226
  1. Atmosphere Pressure
  2. MAP
P2228
P2229

HINT:
  1. When the ignition switch to ON, the intake manifold pressure, "MAP", is approximately equal to atmospheric pressure.
  2. Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).
  3. If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:
    1. Misfire
    2. Combustion noise
    3. Black smoke
    4. White smoke


INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

1.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON and wait for 1 second or more.

  1. Confirm that the DTC is not output again.


NEXT

END