DTC P1626 Idle Signal Output Value Too Low |
DTC P1627 Idle Signal Output Value Too High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Warm up the engine and idle it for 5 seconds | With the engine running at idle, voltage of the ECM IDLO terminal is 0.05 V or less for 5 seconds or more (1 trip detection logic). |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Warm up the engine and idle it for 5 seconds | With the engine running at speeds higher than idle, voltage of the ECM IDLO terminal is 3.4 V or higher for 5 seconds or more (1 trip detection logic). |
|

| 1.CHECK HARNESS AND CONNECTOR (INJECTOR DRIVER - ECM) |
Disconnect the injector driver connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I19-2 (IJEN) - E27-19 (IDLO) | Always | Below 1 Ω |
| I19-2 (IJEN) or E27-19 (IDLO) - Body ground | Always | 10 kΩ or higher |
Reconnect the injector driver connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 2.REPLACE INJECTOR DRIVER |
Replace the injector driver (Click here).
| NEXT | |
| 3.CHECK ANY OTHER DTCS OUTPUT |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
After warming up the engine, idle the engine for 5 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| No DTC is output | A |
| P1626 or P1627 is output | B |
|
| ||||
| B | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 5.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 6.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the GTS to the DLC3.
Clear the DTCs (Click here).
After warming up the engine, idle the engine for 5 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| NEXT | ||
| ||