DTC 43 Air Outlet Damper Control Servo Motor Circuit |
| DTC Code | Detection Item | Trouble Area |
| 43 | The mode damper position does not change when the air conditioning amplifier assembly operates the mode damper servo sub-assembly. |
|

| 1.CHECK HARNESS AND CONNECTOR (MODE DAMPER SERVO - AIR CONDITIONING AMPLIFIER) |
Disconnect the D2 mode damper servo sub-assembly connector.
Disconnect the A44 and A43 air conditioning amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D2-4 - A44-4 (AOD) | Always | Below 1 Ω |
| D2-5 - A44-3 (AOF) | ||
| D2-2 - A43-26 (POA) | ||
| D2-3 - A43-25 (POB) | ||
| D2-1 - A43-11 (SG-2) | ||
| D2-4 - Body ground | Always | 10 kΩ or higher |
| D2-5 - Body ground | ||
| D2-2 - Body ground | ||
| D2-3 - Body ground | ||
| D2-1 - Body ground |
|
| ||||
| OK | |
| 2.REPLACE MODE DAMPER SERVO SUB-ASSEMBLY |
Temporally replace the mode damper servo sub-assembly with a new or normally functioning one (Click here).
Check the mode damper operates normally.
| Result | Proceed to |
| OK | A |
| NG (When troubleshooting according to problem symptoms table.) | B |
| NG (When troubleshooting according to DTC.) | C |
|
| ||||
|
| ||||
| A | ||
| ||