AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Vehicle Speed Signal Circuit |

| 1.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY |
![]() |
Remove the air conditioning amplifier assembly with its connectors still connected (Click here).
Using an oscilloscope, check the waveform of the air conditioning amplifier assembly.
| Item | Content |
| Tester Connection | A44-9 (SPD) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Driving at approximately 20 km/h (12 mph) |
| *a | Component with harness connected (Air Conditioning Amplifier Assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - AIR CONDITIONING AMPLIFIER) |
Disconnect the C26 combination meter assembly connector.
Disconnect the A44 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C26-6 - A44-9 (SPD) | Always | Below 1 Ω |
| A44-9 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER ASSEMBLY |
![]() |
Remove the combination meter assembly with its connector still connected (Click here).
Using an oscilloscope, check the waveform of the combination meter assembly.
| Item | Content |
| Tester Connection | C26-6 - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Vehicle is driven at approximately 20 km/h (12 mph) |
| *a | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||