Home › SUSPENSION & AXLE › SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR COIL SPRING


F049945E01
  1. Install the coil spring and insulator to the lower control arm and frame. Fit the lower end of the coil spring into the recess of the spring lower seat.



2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY


C118719
  1. Install 2 new bushes and the 2 retainers to the shock absorber.

  1. Temporarily install the shock absorber to the axle housing with the nut.



3. INSTALL REAR WHEEL

Torque:
105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several time to stabilize the suspension.



5. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
  1. Tighten the bolt.

    Torque:
    82 N*m{ 816 kgf*cm , 60 ft.*lbf }



6. CONNECT REAR BRAKE TUBE FLEXIBLE HOSE
  1. Install the hose to the 3 way joint.

  1. Install the clip to the flexible hose.

  1. Connect the flexible hose to the brake line.

    Torque:
    23 N*m{ 235 kgf*cm , 20 ft.*lbf }



7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
  1. Connect the No. 3 parking brake cable .



8. INSTALL TAIL EXHAUST PIPE ASSEMBLY
  1. Install the tail exhaust pipe for 2TR-FE .

  1. Install the tail exhaust pipe for 1KD-FTV .

  1. Install the tail exhaust pipe for 1GR-FE .

  1. Install the tail exhaust pipe for 2TR-FBE (Click here).



9. CONNECT REAR SPEED SENSOR LH



10. BLEED BRAKE LINE
  1. w/ VSC:
    (Click here)

  1. w/o VSC:
    (Click here)