Home › SUSPENSION & AXLE › SUSPENSION › REAR UPPER CONTROL ARM

REAR UPPER CONTROL ARM > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. Remove the fuel tank before removing the rear upper arm LH, and remove the center exhaust pipe before removing the rear upper arm RH.



1. REMOVE REAR WHEEL


2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. for 2TR-FE:
    (Click here)

  1. for 1KD-FTV:
    (Click here)

  1. for 1GR-FE:
    (Click here)

  1. for 2TR-FBE:
    (Click here)



3. REMOVE FUEL TANK ASSEMBLY
  1. for 2TR-FE:
    (Click here)

  1. for 1KD-FTV:
    (Click here)

  1. for 1GR-FE:
    (Click here)

  1. for 2TR-FBE:
    (Click here)



4. REMOVE UPPER CONTROL ARM ASSEMBLY


C118723
  1. Remove the 2 bolts, 2 nuts and control arm from the axle housing.

    HINT:
    While fixing the nuts in place, loosen and remove the bolts.