Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B277751
  1. Detach the 16 clips and remove the back door trim board.



4. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY


    E225950
  1. Open the wiper arm head cap.



    E225948
  1. Remove the nut and arm and blade.



5. REMOVE REAR WIPER MOTOR ASSEMBLY


    B117895
  1. Disconnect the connector.

  1. Remove the 3 bolts and wiper motor.



6. REMOVE REAR WIPER MOTOR GROMMET


    E225759
  1. Remove the rear wiper motor grommet.