DTC P0069 MAP Sensor Too High or Too Low |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| 1 second elapses after ignition switch turned from off to ON (starter remains off) | After the ignition switch is turned to ON, the difference between the atmospheric pressure sensor output and manifold absolute pressure sensor output is more than 8 kPa for 0.5 seconds (2 trip detection logic). | ECM |
| DTC No. | Data List |
| P0069 |
|
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0069) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0069 and other DTCs are output | A |
| P0069 is output | B |
|
| ||||
| B | |
| 2.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTC (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||